Wmh53520cb-2 Parts

The Microwave Door is an OEM part for Whirlpool microwaves. It provides access to the cooking cavity while also serving to safely contain microwave emissions. Made of glass, the door allows for easy visibility of foods inside without interfering with cooking performance. 

Symptoms of a bad microwave door include:

• Cracks or chips in the glass that could weaken containment
• Difficulty opening or closing the door smoothly 
• Warping or sagging of the door frame over time
• Leaks that allow the escape of microwave radiation 

Causes of a bad door can be repeated stress from opening and closing, accidental damage, or failure of hinges or latching mechanisms. Improper sealing also risks safety. 

It is compatible with kitchen appliances from Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and Kenmore as well.

This complete microwave door assembly replaces a damaged or non-sealing door to restore proper closure, heat containment, and user access. It includes the outer door, inner liner, handle area, and latch interface in one ready-to-install unit. What it does:

• Replaces a cracked, dented, or warped door that won't close or latch properly
• Restores the microwave's ability to contain heat, sparks, and cooking odors
• Re-establishes the door latch engagement so the oven recognizes door-closed status
• Improves user access when original door handle or hinge area is broken

• Turn power off at the breaker and unplug the microwave before servicing
• Some models require partial disassembly of the microwave cabinet to remove and install the door; follow the OEM service manual
• Handle and mounting hardware may be pre-attached; confirm fit before tightening screws

This outer door panel restores a refrigerator door's exterior appearance and structural integrity. It replaces a dented, cracked or rusted outer door surface to make the appliance look and function like new again. What it does:

• Replaces the refrigerator door's external panel to repair visible damage or corrosion
• Restores a smooth, finished exterior and consistent trim alignment
• Helps protect internal components housed in the door from impact and moisture
• Addresses common symptoms like dents, deep scratches, paint chipping or separated outer trim

• Installation typically requires removing the door from the cabinet and transferring hardware (hinges, handle, trim, insulation) from the old door
• Tighten fasteners to manufacturer torque and verify door alignment and swing after installation
• Keep wiring and insulation protected when separating inner and outer door pieces

This wire harness connects the appliance control to key components, restoring reliable power and signal paths so controls, displays, and functions respond correctly. Replace a damaged or burnt harness to resolve intermittent or lost control operation. What it does:

• Carries power and control signals between the main console/control board and components
• Replaces damaged wiring that can cause intermittent operation, failing controls, or loss of power to circuits
• Helps stop arcing, shorts, or burn marks caused by frayed or melted wires
• Restores proper connections for displays, switches, sensors, and actuators

• Disconnect all power (unplug or shut off breaker) before servicing
• Handle connectors by the housing; do not pull on individual wires
• Route and secure the harness following original clips/fasteners to avoid chafing or heat exposure