Wod51ecoaboo Parts

This wire harness provides the factory-style electrical connections needed to restore secure, organized wiring in your appliance. Replacing a damaged harness helps re-establish reliable power and signal paths for controls and components. What it does:

• Connects multiple internal components with pre-terminated wiring and color-coded connectors
• Ensures correct signal and power routing between control boards, switches, and motors
• Commonly used to address intermittent power, loss of functions, or components that don't respond
• Keeps wiring bundled and secured to prevent chafing or short circuits

• Disconnect power (unplug or switch off breaker) before starting any repair
• Match connector shapes and wire colors; route and secure harness along the original path
• Inspect connectors and insulation; replace the entire harness if any wire or terminal is damaged

Color: Black

This Deflector-Heat is a replacement heat shield that helps direct and protect internal dryer components from excess heat, maintaining safe airflow and consistent drying performance. What it does:

• Redirects heat away from sensitive housing and components to prevent heat damage
• Helps maintain proper airflow through the dryer drum and venting system
• Can reduce hotspots that cause premature wear on nearby parts
• Fits into the dryer cabinet where the original heat deflector was mounted

• One Deflector-Heat (heat shield), single piece as shown

• Disconnect power (and gas supply for gas dryers) and allow the appliance to cool before starting
• Typically installed from inside the dryer cabinet; panel removal and basic hand tools are usually required
• Keep screws and mounting hardware from the original part; replace only if explicitly listed as included

This tube-vent is the replacement exhaust tube that channels hot, moist air from the dryer to the external vent, helping the dryer remove moisture efficiently and operate safely. What it does:

• Routes dryer exhaust from the drum area to the vent outlet for proper airflow
• Prevents exhaust air leakage that can reduce drying performance
• Helps avoid lint buildup in the cabinet area when intact
• Commonly replaced when cracked, crushed, or collapsed and causing poor drying or unusual odors

• One tube-vent

• Disconnect power (and gas, if applicable) before starting any repair
• Inspect and clear the external vent path; secure tube with appropriate clamps or fasteners
• Do not kink, stretch, or sharply bend the tube — ensure a smooth airflow path
• If you detect heavy lint buildup or damage to ducts, clean or replace the entire venting run and follow local building codes

This complete 30" oven door assembly replaces a damaged or worn oven door to restore proper sealing and appearance. The stainless finish gives a clean, modern look while helping contain heat for consistent cooking results. What it does:

• Replaces the full oven door to restore a secure seal and proper closing
• Helps stop heat leaks that can cause uneven cooking or excessive exterior heat
• Restores damaged or cracked outer glass, trim, or latch components
• Improves appliance appearance when the original door is dented or scratched

• Disconnect power to the oven and allow all surfaces to cool before servicing
• Door assemblies can be heavy and awkward; use two people to lift and align
• Follow OEM instructions for hinge alignment and secure fastenings to ensure proper sealing
• If glass is cracked or broken, wear safety gloves and eye protection.