Wrt519szdw11 Parts

This door trim is the outer decorative and protective ring that fits around the appliance door opening to restore appearance and help secure the door assembly. It replaces damaged, cracked, or worn trims to refresh the door finish. What it does:

• Covers and protects the edge of the door opening and the door glass assembly
• Restores a clean, finished look when original trim is cracked, chipped or discolored
• Helps keep the door components aligned and seated correctly
• Common symptom: visible cosmetic damage or a loose/shifted door bezel

• One door trim piece as shown

• Disconnect power and water before starting any repair
• Handle trim and any attached glass carefully to avoid damage or injury
• Removal/replacement typically requires removing the door or door panel; follow the appliance service manual

The Gasket-Door (black) is an OEM component specifically designed for Whirlpool refrigerators. This rubber gasket forms a seal around the perimeter of the refrigerator door opening. It helps maintain interior temperatures and humidity levels.

Symptoms of a bad door gasket include:

• Inability to properly chill compartments and freezing performance issues  
• Excessive frost or moisture inside refrigerator sections
• Higher energy costs from inefficient temperature regulation
• Warm air infiltration indicated by higher than normal interior temps

Causes of degraded gasket performance typically include cracks, tears or compression set deterioration that compromise the sealed barrier over many years of use. 

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models. 

This is a replacement refrigerator door handle that restores a secure grip and smooth opening for compatible Whirlpool refrigerators. It replaces a cracked, loose, or missing handle to improve everyday use and appearance. What it does:

• Provides a sturdy grip to open and close the refrigerator door
• Replaces damaged, cracked, or worn door hardware that affects operation or looks
• Restores proper alignment at the mounting points when used with original fasteners
• Matches OEM fit and finish for a factory-appearance replacement

• Installation requires basic hand tools; retain original mounting screws unless new fasteners are specified
• Support the door while removing and installing the handle to prevent damage or dropping
• Do not overtighten screws — snug is sufficient to avoid stripping or cracking the handle

This door trim replaces the outer decorative edge on a refrigerator door to restore appearance and proper sealing. It gives a clean, finished look and helps keep the door edge aligned with the cabinet. What it does:

• Replaces cracked, dented or scratched door trim to improve appearance
• Restores the trim that helps hold the door gasket edge in place
• Stops draft or uneven sealing that can occur when the trim is loose or damaged
• Prevents further chipping or moisture intrusion at the door edge

• Disconnect power to the appliance before starting any repair
• Remove the door or inner liner fasteners per manufacturer instructions to access trim
• Use basic hand tools (screwdriver, nut driver) and retain all fasteners for reassembly
• Check door alignment after reinstalling

A small retainer clip that secures panels, hoses or wiring to keep components in place and reduce noise from loose parts. Replacing a worn or broken clip restores proper fit and helps prevent intermittent contact or rattling. What it does

• Secures trim, panels, hoses or wire harnesses to mounting points to prevent movement.
• Keeps components aligned so switches and seals engage correctly.
• Stops rattling or vibrating noises caused by loose parts.
• Helps prevent abrasion or chafing of wires and hoses by holding them away from edges.

• Install by snapping or sliding the clip into the factory mounting slot; use needle-nose pliers if needed.
• Power off and unplug the appliance before accessing internal parts.
• Inspect surrounding mounts and mating tabs for damage; replace if worn for a secure fit.
• If removal is difficult, apply a small amount of penetrating lubricant and work carefully to avoid breaking adjacent plastic.