Wtvc6330us/10 Parts

The Foot is an OEM component specifically designed for select Bosch vented dryers requiring balanced tumbling motions. As an anchor point, it supports revolving drum weights during operation.

Causes requiring replacement relate to cumulative use wearing down attached glides and compromising smooth rotations. Physical damage exposing reinforcement fibers risks accelerated failure. 

Symptoms signaling the need for a new foot involve:

• Shaking or off-balanced drum movements from failed supports
• Loosened fasteners enabling unintended dislodging or displacement
• Cracked housings no longer stabilize intended weight distributions

This OEM Bosch replacement foot is also compatible with Thermador, Gaggenau and select Kenmore dryers relying on anchored rotational components. Correct installation restores intended weight balancing.
 

This is a factory-style screw used to secure appliance panels and components for a reliable, low-profile hold. It replaces worn or missing fasteners to stop rattling and keep parts aligned during normal use. What it does:

• Secures trim, panels, brackets or small components in place
• Stops loose parts that can cause rattling or vibration noises
• Restores correct fit where a missing or damaged screw allows gaps
• Works as a direct replacement when the original fastener is lost or stripped

• One screw

• Disconnect power and water before servicing the appliance
• Start the screw by hand to avoid cross-threading; use the correct driver bit
• Tighten snugly but avoid over-torquing to prevent stripping or part damage
• Keep removed hardware organized to ensure correct reassembly

This door switch is the electrical interlock that senses the door position and allows the appliance to run only when the door is closed. It restores normal door sensing to prevent unexpected operation and enable cycles to start. What it does

• Detects whether the door is closed and completes the circuit so the appliance can start or continue a cycle.
• Prevents operation when the door is open, improving safety and preventing leaks or heat loss.
• Common symptom: appliance will not start, stops mid-cycle, or shows door-related fault codes when the switch fails.
• Replaces a worn or unreliable door sensing component that causes intermittent starts or shutdowns.

• One door switch

• Disconnect power (unplug or shut off circuit breaker) before attempting replacement to avoid shock.
• Handle connectors and wiring gently; verify connector orientation before reassembly.
• Reassemble panels and test door operation and a short cycle to confirm correct function.

This hose inlet is the water connection hose that routes incoming water to the appliance's inlet valve, restoring proper water feed for cycles. It's a direct-fit replacement designed to match the original part's fit and function. What it does:

• Connects the home water supply to the appliance's inlet valve so water can enter for wash/fill cycles
• Restores proper water flow when the original hose is cracked, split, or leaking
• Helps prevent leaks at the machine entry point when the hose and clamps are properly installed
• Works as the factory-style replacement to maintain correct routing and seal

• One hose inlet

• Turn off power and shut off the water supply before attempting replacement
• Drain residual water from the supply line and appliance to minimize spills
• Inspect and replace any worn clamps or seals; hand-tighten then secure clamps per manufacturer guidance

This flat washer secures fasteners and helps distribute clamping force to protect parts from pull-through and wear. It's a small but critical hardware piece that helps maintain proper alignment and reduce vibration in the appliance. What it does:

• Sits under a nut or bolt to evenly spread load and prevent surface damage
• Helps keep fasteners tightened and reduces loosening from vibration
• Protects mating surfaces from wear and deformation
• Can reduce rattling or vibration-related noise when used as intended

• Disconnect power and water before accessing internal components
• Replace like-for-like; do not force or modify the washer to fit
• If other hardware is corroded or damaged, replace affected fasteners as a set