Wtw58408w0 Parts

Used on the pressure switch hose harness.

This complete lid assembly replaces a cracked, bent, or missing washer lid so the top-load tub can be securely covered and the appliance can safely operate. Restores a proper closure and helps prevent splashes and loose items from falling out. What it does:

• Replaces a damaged or broken lid to restore full top access coverage
• Allows the lid to close and latch properly so the washer can run as designed
• Helps contain water and detergent during the wash cycle to reduce splashing
• Provides the correct mounting points and trim for a factory-like fit

• Designed for drop-in replacement;
• Power off and unplug the washer before beginning any service
• Handle carefully to avoid scratching the finish; use protective gloves if needed

A small retainer clip that secures panels, hoses or wiring to keep components in place and reduce noise from loose parts. Replacing a worn or broken clip restores proper fit and helps prevent intermittent contact or rattling. What it does

• Secures trim, panels, hoses or wire harnesses to mounting points to prevent movement.
• Keeps components aligned so switches and seals engage correctly.
• Stops rattling or vibrating noises caused by loose parts.
• Helps prevent abrasion or chafing of wires and hoses by holding them away from edges.

• Install by snapping or sliding the clip into the factory mounting slot; use needle-nose pliers if needed.
• Power off and unplug the appliance before accessing internal parts.
• Inspect surrounding mounts and mating tabs for damage; replace if worn for a secure fit.
• If removal is difficult, apply a small amount of penetrating lubricant and work carefully to avoid breaking adjacent plastic.

Size: 10 - 24 x 3/8

This end cap is a replacement outer trim piece that restores proper fit and finish to the appliance and helps protect internal components from debris. It returns a secure, clean edge where the original cap was damaged or missing. What it does:

• Covers and protects the exposed end of the housing or panel to prevent debris intrusion and wear
• Restores proper alignment of adjacent trim and panels for a snug fit
• Helps stop rubbing, vibration noise, or snagging caused by cracked or missing trim
• Provides the original appearance and protective edge after damage

• One end cap

• Disconnect power to the appliance before beginning any repair
• Remove any fasteners or retaining clips holding the old cap; keep hardware if reusable
• Snap or fasten the replacement cap into place, ensuring proper alignment with adjacent trim
• Test the appliance for proper operation after reassembly

Color: White.

Includes gasket sealer.