Cam Riser Parts

This cam engages the door hinge to give a refrigerator door a controlled, self-closing action that helps keep the door shut and maintain internal temperatures. It's a direct-fit hinge cam used where the OEM calls for an auto-close cam. What it does:

• Guides the hinge to provide a smooth, late-stage self-closing action for the door
• Helps prevent doors from being left ajar, which can cause temperature loss or spoiled food
• Restores proper door alignment and closing feel when a worn cam causes sticking or drift
• Works as the hinge cam in assemblies designed for an auto-close mechanism

• One cam, auto close (right door hinge) as shown

• Designed to replace the original hinge cam; follow the appliance manufacturer's hinge/disassembly instructions
• Turn off power and remove food from the door area if work affects sealed compartments; unplug if required by model
• Handle edges and spring/tensioned hinge parts with care; springs can release suddenly

This stop door is a small replacement door stop that helps limit and stabilize door movement for proper closing and alignment. Restores consistent door positioning to reduce slamming and wear on the hinge area. What it does:

• Acts as a physical stop to limit door travel and prevent over-rotation
• Helps the door latch and seal properly by holding it in the correct resting position
• Reduces noise and impact from abrupt door closing
• Protects hinge components and surrounding cabinet from excess wear

• Stop door

• Install on the door hinge area where the original stop is mounted; verify orientation before tightening
• Use basic hand tools; avoid over-tightening fasteners which can damage plastic parts
• Disconnect power or unplug the appliance if reaching into areas with electrical components

A direct-replacement stop door that secures and limits appliance door movement to help maintain proper alignment and prevent over-travel. Fits common GE refrigerator/freezer door assemblies where a small molded stop is used. What it does

• Stops door or drawer over-travel and helps keep the door aligned in its track or hinge
• Reduces banging or rubbing caused by a loose or broken stop
• Restores normal door closing behavior when the original stop is damaged or worn
• Works as the small molded bumper/stop component in the door assembly

• Disconnect power to the appliance before attempting service to avoid injury
• Access the door stop by opening the door and removing any trim or screws that cover the mounting area
• Replace the stop by removing the broken part and snapping or fastening the new stop into the same location

This stop door is the replacement dispenser door that covers the ice/water chute and helps control dispensing. It restores proper closure to prevent drips and ice spillover and keeps the dispenser area sealed when idle. What it does

• Replaces the dispenser stop/cover to block the chute when not in use
• Helps prevent water drips and ice from falling into the dispenser well
• Restores a tight closure to reduce cold air loss from the cabinet
• Can resolve symptoms like a stuck or broken dispenser door or visible gaps at the chute

• One stop door

• Disconnect power to the appliance before beginning any service
• Usually installs with a few screws or snap clips; basic hand tools typically required
• Inspect surrounding trim and actuator parts for wear while replacing the door