Wslp1500 Parts

Secure your washer's drain hose with this drain hose strap. It keeps the hose positioned at the standpipe or laundry tub, helping prevent movement, dislodging, and messy leaks when vibration increases during drain and spin cycles.

• Secures the drain hose to a standpipe or utility sink, per installation guidelines
• Helps prevent the hose from backing out or spraying water during operation
• Reduces strain and kinking by keeping the hose routed in place
• Replaces a missing, cracked, or broken strap

• Unplug the washer and turn off water supply before starting
• Position the drain hose in the standpipe or tub and tighten the strap to secure it without kinking the hose
• Maintain the manufacturer-recommended air gap and hose height per your installation manual
• Run a quick drain/spin to ensure the hose stays secured and there are no leaks

This suspension assembly supports the washer tub and helps stabilize the appliance during the spin cycle to reduce vibration and drum movement. It restores proper tub positioning for smoother, quieter operation. What it does:

• Suspends and dampens the washer tub to minimize excessive vibration and rocking during spin.
• Helps keep the drum centered to prevent noisy operation and uneven loads.
• Reduces wear on other suspension and bearing components by maintaining correct alignment.
• Commonly replaced when the tub sags, bangs during spin, or the washer leans.

• One blue suspension assembly.

• Disconnect power and water supply before beginning work.
• Support the tub and follow manufacturer service instructions when removing springs or fasteners.
• Use appropriate tools and avoid forcing parts; replace in matched sets if the OEM recommends.

This SCR cover-back is a replacement cover that protects the appliance's SCR module and wiring, helping prevent contact damage and debris buildup for reliable operation. It restores the original protective shielding. What it does

• Protects the SCR module, control board area, and wiring from physical damage and dirt
• Helps reduce risk of electrical shorting from loose debris or accidental contact
• Maintains factory routing and placement of components behind the control area
• Restores the appliance's original protective enclosure after service

• One SCR cover-back replacement panel

• Designed to fasten using the original screws or mounting hardware; all retained hardware is present
• Disconnect power before servicing to avoid shock or damage to electronic components
• Handle with care to avoid bending mounting tabs; align tabs before tightening screws
• If control boards or modules were removed for access, recheck connections before reapplying power

This inlet valve assembly controls incoming water flow to your appliance, restoring proper fill and stopping unwanted water flow when the original valve fails. Designed as a direct replacement for the OEM valve body. What it does

• Opens and closes to allow water into the appliance when a fill cycle is requested
• Stops water flow to prevent overfilling or continuous fill when the valve is faulty
• Common symptom: appliance won't fill or fills intermittently
• Common symptom: water flows continuously or leaks at the valve connection

• Turn off water supply and unplug the appliance before starting any repair
• Replace with the exact OEM-identical valve to ensure proper fit and function
• Inspect inlet screens and supply lines for debris or damage while replacing valve
• After installation, restore power and water, run a test cycle, and check for leaks