Search Results

By replacing the switches. Read more

Replaced the motor with a direct replacement part. The wiring was not the same because the switch on the motor was different. The instructions that came with the motor were enough for me to figure out what to do. Read more

Ordered parts arrived in two days. Ten minute fix with one wrench. Should have done it years ago. Read more

Replaced two switches that controlled two front burners. One controlled three different burner sizes options in one burner. The other was the speed burner, basically three different burner options in one burner. Read more

You have to take the knob off the broken part, then buy the new switch element and fix it. To do this you turn the power off, take out 6 fasteners to release the front panel of the stove and replace the switch element. Then put it all back together. Very simple. But if the knob was designed better it would not have broken in the first place. It looks nice, but this is the third time I have had to fix one. Read more

• Light not working

Ordered switch....turned out it was the socket that was bad...ordered socket.....quick install....light works Read more

I replaced the cycle switch, fixing the lack of heat. The timer switch replacement fixed the auto cool down. I watched a cycle switch replacement on Youtube, demonstrating removal of the top console, which answered the only question I had about the repair. The timer switch was a hundred bucks. The only thing to be said about that is that it was a lot cheaper than a repairman or replacing the dryer. Read more

I had to pull and clean the pressure sensor switch four times in a year. Each time more gunk accumulated. When that happens the sensor does not close the water valve. The dishawsher keeps filling and the water comes out through the overfill port. The water then goes in the catch basin under the washer and floats the emergency switch. This cuts off the water but keeps the pump running just in case. Tripping the circuit breaker is only a temp fix. What happens is the water level may have... Read more

Very easy replaced switch. Read more

• Will not stop filling with water
• Will not fill with water

Reviewed troubleshooting tips and identified problem as "water level switch". Watched repair video, which was very helpful. Ordered part on a Sunday, which arrived the following Tuesday. Repair was easy the fix was successful. Read more

Ordered the freezer door switch and the light. Replaced the freezer door switch and the light and everything is back to normal. Replaced both in less than 15 min with no problems. Read more

Replaced the switch in the back panel, SUPER easy!! Read more

Replaced the Infinite Switch. Simple fix using only a screwdriver. Read more

• Won't start
• Element will not heat

1) I installed 4 ea new Whirlpool 700855K switches. (The old switches had INF-240P-871 stamped on them. 700855K was the cross-referenced P/N.) The installation was easy. There is slight difference in the terminal arrangement: 1) the old switch has raised terminals whereas the new switch has recessed terminals (for safety), and 2) the terminal markings are slightly different: The old switch has L1/L2/P/H1/H2 (5 terminals). The new switch has L1/L2/P/HC/H1(Also five terminals. I saw where one... Read more

The ordeal began after wiping around burner knobs with a moist paper towel with cleaner and wrapping the towel around the burner knob shaft to clean around it. The cooktop stopped sparking on all the 5 burners and no red LED light. There was gas flow and I could light the burner using a lighter. I looked up and found a couple of good youtube videos on troubleshooting and also came upon the AppliancePartsPros.com site. I opened the cooktop (youtube video helped) after turning off the gas supply... Read more

I thought initially it was a hose because it was leaking water from the bottom. On the small and medium load it didn't leak. I watched it on the large setting and noticed the water didn't shut off initially so therefore it was over filling. I ordered a switch pressure switch from Appliance Parts Pros and received it in two days. I replaced the switch, put the washer together and now it works like new. The wife is very happy to have her washer back working better than ever! Thanks! Jerry Read more