Barry F Highlands Ranch , CO October 04, 2015 Appliance: Maytag Washer- Horizontal Axis MAH4000AWW Spin cycle stopped working After much internet research (primary YouTube) as to why my Maytag Neptune washing machine's spin cycle stopped working, I ordered the parts I needed to fix it. Sure enough, it was a failed wax motor and a blown control board at fault. After replacing both parts, we have a functioning washing machine again. While I was at it, I replaced the soap dispenser's bezel and lid since they were deteriorating and now we have a "new" washer! I also replaces the thermostat in the matching dryer and we now have multiple levels of heat vs. just cool or very hot. Great to have a reliable place to get the parts I needed. I have used AppliancePartsPros several times over the past for +/- 6 years. They have always had the parts I needed and they have been there to answer any questions I may have before and during installation. I highly recommend them. Read More... 10 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Pliers, Screwdrivers, Socket Set
Chris H Ashland , VA July 04, 2015 Appliance: Model MAYTAG NEPTUNE Washer would not go into spin cycle Replaced wax motor switch and door lock switch. Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Scott G Tallahassee , FL March 24, 2015 Appliance: Maytag Washer- Horizontal Axis MAH3000AWW Decaying soap dispenser tray and cover I removed the 4 screws holding the dispenser tray, removed the bad parts, and installed the new parts. I only needed the pliers to remove the 2 hinge pins in the old cover and reinstall them in the new cover. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers, Screwdrivers
Laura M Chicago , IL January 27, 2017 Appliance: Maytag Washer- Horizontal Axis MAH4000AWW The top flap for the detergent was broke over the years the hinges wore out so it needed to be repaired Ordered the parts and assembled it in less that 5 minutes and now it looks like new. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Brett H Roseville , CA February 20, 2017 Appliance: Maytag Washer- Horizontal Axis MAH4000AWW Drive belt slipping Used new belt and isolator kit, following the video instructions on the website. Extremely easy, went very well. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Wrench Set