Parts for Thermador ESC30CVWC: 01 - Body & Control Panel Parts

This white clock knob replaces a damaged or worn timer/control knob, restoring tactile control and clear position indexing for oven/timer dials. It matches the original fit and appearance for straightforward replacement. What it does:

• Provides a solid grip to turn the oven/timer control or clock mechanism
• Restores accurate knob indexing and detent feedback for proper settings
• Stops slipping or spinning caused by cracked or stripped knobs
• Helps avoid further wear on the shaft by replacing a degraded knob

• Pull off the old knob straight from the control shaft; press the new knob fully onto the shaft until seated
• Disconnect power or follow appliance safety instructions when accessing internal controls

This part has been discontinued by the manufacturer and is no longer available.

This glass retainer bracket secures oven door glass and helps keep the inner panel aligned for a stable, sealed door. Replacing a worn bracket restores proper glass support and reduces rattling or misalignment. What it does:

• Holds the oven door inner glass in place and maintains panel alignment.
• Prevents the glass from shifting, reducing noise and vibration during use.
• Helps restore a tight door fit that can improve heat retention and consistent cooking.
• Common symptom: loose, rattling, or misaligned door glass.

• One white glass retainer bracket.

• Disconnect power to the appliance before starting and allow surfaces to cool.
• Handle door glass carefully; use gloves and place on a padded surface to avoid damage.
• Verify orientation and fit before tightening fasteners; do not overtighten to prevent cracking the glass.

A flanged gray bushing that cushions and supports the appliance door glass, helping reduce noise and wear where the glass meets the door frame. Replaces a worn or damaged bushing to restore proper fit and quiet operation. What it does:

• Positions and stabilizes the door glass at the flange to prevent rubbing and vibration
• Cushions the glass to reduce rattling and chatter during operation
• Helps maintain correct spacing to avoid glass contact with metal edges
• Small part failure can allow the glass to shift, vibrate, or produce noise

• One flanged gray door glass bushing

• Disconnect power (unplug or switch off circuit breaker) before beginning any service
• Handle door glass carefully; support it to prevent breakage when removing/installing the bushing
• Replacement typically requires partial door disassembly—follow OEM instructions
• Inspect adjacent clips, seals, and mounting surfaces for wear and replace as needed