Parts for Gaggenau AH400-730: 01 - Body Parts

This is a replacement fluorescent lamp starter designed for use with 80W, 240V fixtures. It helps the lamp reach full brightness reliably so lighting cycles start and run normally. What it does:

• Provides the initial pulse to ignite fluorescent tubes in compatible fixtures
• Commonly restores lamps that fail to start or take multiple strikes to light
• Can stop or reduce continuous flickering or rapid flashing at startup
• Works with starter-type ballasts specified for 80W / 240V operation

• Disconnect power to the fixture before servicing to avoid shock
• Typically replaces a plug-in starter in the fixture's starter holder—pull old starter straight out and push the new starter into place
• Confirm fixture voltage and lamp wattage match the starter specifications before installing

This is a replacement cap designed to fit AH 320/400 series assemblies and restore the original cover/seal function. It helps keep internal components protected from debris and maintains the intended fit of the assembly. What it does:

• Covers and protects an exposed opening or connector on the AH 320/400 assembly
• Helps keep out dirt, dust and moisture that can cause wear or operational issues
• Restores the proper fit and alignment of the surrounding components
• Prevents accidental contact with the covered area during use or service

• Turn off and unplug the appliance (or disconnect power) before servicing
• Remove any fasteners or retaining clips carefully to avoid damage; press or snap the cap into place as designed