Parts for Ge ZGG36L30ASS: 01 - Gas Grill Parts

This replacement side body panel restores the exterior cabinet surface for a clean, finished look and protects internal components from dust and damage. It fits the refrigerator cabinet side and matches OEM mounting points. What it does:

• Replaces a dented, rusted, or scratched cabinet side to restore appearance
• Covers and protects internal insulation, wiring, and refrigeration components
• Provides OEM-style mounting and alignment for proper panel fit
• Helps maintain cabinet rigidity and overall appliance stability

• One side body cabinet panel

• Disconnect power to the appliance before starting any repairs
• Removal typically requires taking off trim, doors, or adjacent panels to access mounting screws
• Handle edges carefully; sheet metal edges may be sharp
• Align existing mounting holes and hardware; use OEM fasteners if available

This rotis burner housing replaces the worn or damaged housing that supports and aligns the burner on your range, restoring stable burner placement and proper burner cap seating for safer cooking. What it does:

• Secures the burner assembly and positions the burner head and cap
• Helps maintain an even flame by keeping burner parts aligned
• Addresses symptoms like burner caps that wobble, uneven flames, or improper burner seating
• Prevents contact between burner components and the cooktop while in use

• Turn off gas supply and disconnect power before servicing gas ranges
• Remove grates and burner caps, then lift out the cooktop or control panel as needed to access the housing
• Inspect surrounding gaskets and seals; replace if brittle or damaged

This single grill rack replaces a worn or damaged 36" monogram-style grill rack to restore proper food support and even broiling. It installs in the grill cavity to hold cookware or food during high-heat cooking. What it does:

• Provides a sturdy surface for grilling and broiling inside the oven or grill cavity
• Allows hot air to circulate around food for more even cooking
• Replaces racks that are bent, warped, or rusted and no longer hold cookware securely
• Helps prevent food from slipping into the burner area or onto the grill floor

• One 36" single grill rack

• Allow the appliance to cool and disconnect power before replacing the rack
• Slide the rack into the existing support slots; no special tools normally required
• Inspect support rails for damage and ensure the rack seats evenly to avoid tipping
• Follow all safety instructions in your appliance owner's manual

Replacement H-shaped surface gas burner for select GE ranges that restores proper flame distribution and cooking performance on the cooktop. Replaces damaged or warped H burners to help ensure even heating. What it does:

• Delivers gas to the H-shaped surface burner position to produce stable cooking flames.
• Restores even heat when a worn or damaged burner causes uneven cooking or low flame.
• Helps address symptoms like flickering or lifting flames, visible warping, cracks, or heavy corrosion.
• Serves as the direct replacement component for the H-style burner assembly on compatible gas cooktops.

• Turn off the gas supply and disconnect power to the appliance before beginning any work.
• Remove grates and burner caps to access the burner; handle parts carefully to avoid damage.
• After installation, check for steady ignition and test for gas leaks with a soapy-water solution—do not use an open flame.

This heat shield protects the oven cavity and surrounding components from excessive heat, helping prevent damage and maintain safe operation. It fits where the original shield has become warped, corroded, or missing. What it does:

• Redirects and absorbs oven heat to protect nearby wiring, insulation, and cabinet panels
• Helps maintain proper internal temperature distribution for safer, more reliable operation
• Prevents heat-related damage that can cause discoloration, melting, or premature component failure
• Commonly replaced when the shield is dented, rusted, or loose and no longer secures correctly

• Disconnect power (and gas if applicable) before beginning any repair
• Wear work gloves and eye protection; edges may be sharp
• Compare the new shield to the original for correct orientation and mounting hole alignment