Parts for Maytag DFC1500AAX: 02 - Body (Dfc1500aax-1) Parts

This stopper assembly seals the drain opening to allow tubs or sinks to fill and hold water. It replaces a damaged or worn stopper so you can restore proper fill-and-hold function and stop unwanted leaks. What it does

• Seals the drain to hold water for washing or soaking
• Opens and closes to allow controlled draining when needed
• Stops water from leaking around a worn or damaged stopper
• Restores normal fill-and-drain operation when the original stopper no longer seals

• One stopper assembly as shown

• Turn off water supply and remove standing water before starting
• Basic hand tools usually required; follow the appliance or sink manufacturer instructions
• Inspect surrounding drain and seals during replacement; replace damaged gaskets if present

This mounting gasket creates a tight, cushioned seal where a component attaches to its housing or bracket. Replacing a worn seal helps stop leaks and rattles while restoring a secure, reliable connection at the mounting point.

• Forms a seal between two mounting surfaces to help prevent leaks or seepage
• Cushions and isolates vibration for quieter operation
• Helps maintain proper alignment of the mounted component
• Replace if the gasket is cracked, flattened, brittle, or no longer sealing

• Disconnect power and shut off water or gas, if applicable
• Note the gasket's orientation before removal
• Clean and dry both mating surfaces; remove all old gasket material and residue
• Seat the new gasket evenly; reassemble and tighten fasteners snugly without overcompressing; test for leaks/operation

This installation kit includes the manufacturer-specified components needed to complete a secure, correct install of the designated appliance or accessory. Use it to replace missing pieces and finish the job with proper fit, alignment, and stability.

• Provides the parts required by the manufacturer to complete installation
• Helps ensure secure mounting and correct positioning
• Useful for new installs, re-installs, or when original hardware is missing or damaged
• Common indications you need this kit: incomplete installation, loose fit, or missing hardware

• Disconnect power and shut off any water supply before starting
• Follow the installation instructions provided with the kit and your product
• Use appropriate tools; check level and clearances before final tightening; get help lifting heavy units