Parts for Thermador ESC30B-01: 05 - Snorkel Parts

Color: metallic. Measures about 13-1/2 inches wide by 5 inches high.

The Grease Filter is an OEM part for Bosch ranges and cooktops. It is responsible for capturing and containing grease, oils, and other vapors produced from cooking to help keep indoor air fresh and prevent buildup. Regular cleaning is important to maintain optimal performance.

Causes of a bad grease filter can include excess buildup that blocks airflow from frequent high-heat cooking. Exposure to flames or excessive heat may cause damage over time as well.

Symptoms of a bad grease filter include:

• Reduced suction power and airflow from the range hood
• Grease accumulation on surrounding surfaces below the hood
• Unpleasant cooking odors escaping into the kitchen rather than being vented outside

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

This part has been discontinued by the manufacturer and is no longer available.

This upper snorkel limit switch detects the snorkel assembly position and signals the dishwasher control so cycles run correctly. Replacing a faulty switch restores reliable control of the snorkel mechanism and helps prevent cycle interruptions. What it does:

• Senses the upper snorkel position and sends a signal to the appliance control
• Helps prevent overfill or incorrect snorkel operation when working properly
• Faulty switch can cause cycle interruption, failure to advance, or snorkel-related errors
• Works as the control-point for the snorkel mechanism that affects water handling

• Disconnect power to the appliance before beginning any repair
• Turn off and/or disconnect water supply if required for access
• Remove access panels or trim as needed to reach snorkel assembly; handle clips and connectors carefully
• Test electrical connections and proper operation after installation

This part has been discontinued by the manufacturer and is no longer available.

This is a #8-32 x 1/4-inch pan-head screw with red zinc finish used to secure appliance panels and small components. It replaces deteriorated or missing fasteners to restore proper fit and reduce rattling or loose parts. What it does:

• Fastens trim, panels, brackets, and small assemblies where a #8-32 x 1/4 pan-head screw is specified
• Provides corrosion-resistant holding with a red zinc finish for long-term fit
• Stops loose or vibrating panels and helps maintain proper alignment
• Matches OEM thread size and head style for correct seating in threaded holes

• Screw

• Disconnect power to the appliance before servicing to avoid electrical hazards
• Use a #1 Phillips driver sized to the screw head; apply steady pressure to prevent cam-out
• Tighten until snug—do not over-torque to avoid stripping threads or damaging parts
• If threads are damaged, replace the mating insert or stud per manufacturer guidance