Parts for Thermador CMT127N-01: 15 - Lower Oven Door Parts

This replacement shim provides precise spacing and alignment for appliance components, helping secure mounts and maintain proper clearances for reliable operation. Use when parts sit unevenly, rub, or require minor alignment adjustments. What it does:

• Creates or restores correct spacing between mating parts to prevent rubbing and binding
• Helps stabilize and align panels, brackets, or assemblies for smoother operation
• Can reduce vibration and noise caused by misaligned components
• Supports fasteners or mounting points where a thin precision spacer is required

• One shim

• Disconnect power and water (if applicable) before beginning any repair
• Verify correct shim location and orientation against the service manual or parts diagram
• Handle carefully — edges may be sharp; wear gloves if needed

Secures oven door glass and keeps the inner panel aligned. Replace if your bracket is cracked, broken, or missing to restore proper glass support.

This stainless-steel air shield protects airflow channels and internal components from heat and debris, helping maintain proper ventilation and part longevity. Designed as a direct replacement for the listed Bosch shield assembly. What it does

• Directs and protects airflow to help maintain correct internal temperatures
• Shields nearby components from heat and debris that can cause wear or damage
• Restores proper fit and alignment where a damaged or missing shield causes rattle or airflow disruption
• Helps reduce noise caused by loose or missing shielding

• One stainless-steel air shield

• Replace with appliance powered off and disconnected from its power source
• Handle edges carefully; wear gloves to avoid cuts from sharp metal
• Verify orientation and fastener locations before tightening to avoid interference with moving parts
• If screws or clips are missing or damaged, replace them with OEM-specified fasteners

Replacement door handle with end caps for your wall oven. Restores the exterior appearance when the original handle is cracked, broken, or missing.

This is a white handle spacer that fits between a door handle and the appliance panel to provide correct alignment and a finished appearance. It restores proper handle spacing and helps the handle sit flush. What it does:

• Positions and supports the door handle so the handle mounts evenly and securely
• Maintains correct clearance between handle and door or trim for smooth operation
• Restores alignment and appearance when the original spacer is cracked, worn, or missing
• Helps prevent handle wobble or contact damage to the door surface

• Designed for straightforward replacement; remove the handle per your model instructions before swapping the spacer
• Use basic hand tools; avoid overtightening fasteners to prevent cracking the new spacer
• Disconnect power (or follow appliance-specific safety steps) when working near electronic controls or wiring

This part has been discontinued by the manufacturer and is no longer available.

This nickel-plated truss head screw secures cooktop components and panels. Replace if stripped, corroded, or missing during appliance maintenance.

Truss head Phillips mounting screw for compactor installation. Replace if screw is stripped, missing, or damaged during disassembly. Secures components.

Secures the glass cooktop to the range frame. Replace if clip is cracked, broken, or missing to properly hold the cooktop surface in place during use.

Replace your oven door glass spacer if it's cracked, broken, or missing. This spacer sits between glass panels in range oven doors for proper alignment.

Replaces the interior glass pane in your oven door assembly. Needed when the original inner glass is cracked, shattered, or broken. Restores visibility.

Replaces the interior glass pane in your oven door assembly. Needed when the original inner glass is cracked, shattered, or broken. Restores visibility.