Parts for Briggs & Stratton 20L236-0111-G1: Alternator, Electric Starter, Ignition Parts

This genuine OEM part is a rocker switch for lawnmower engines. A rocker switch is the component that allows the user to power the engine. If the rocker switch is no longer functioning and not turning the engine on and off as intended, it might need to be replaced. While replacing a rocker switch may seem like a difficult task, it is actually a simple fix.To replace the rocker switch, pry it off using a flathead screwdriver. Once removed from the mower, unplug the wire harness attached to it. Once unplugged, replace with the new switch. Snap the switch back into its original position and test if it has been installed correctly. If the mower turns on and the engine is able to start, then the installation was a success.This replacement part is sold individually and is compatible with Briggs and Stratton lawnmowers.

This genuine starter solenoid transfers electrical current from the battery to the starter during the engine starting process, allowing the engine to engage. This part could become worn over time or develop electrical malfunctions, which could eventually lead to a need for a full replacement. In the event that the solenoid goes bad, it could result in poor engine performance or not permit the engine to start at all. This replacement part could provide an exact fit for compatible lawn and garden units. This genuine OEM solenoid from Briggs & Stratton is manufactured to exact specifications. It is compatible with engines used in select models of generators and other lawn and garden equipment made by the brand. This genuine OEM part is sold individually and does not include any hardware or additional components. It is imperative to disengage the spark plug and allow the engine to cool before performing engine repairs like replacing the starter solenoid. A wrench or socket set will be required to disconnect the old solenoid and install the new unit and gloves should be worn for hand protection.

This brush retainer is part of the starter motor on many types of lawn and garden machinery. It comes with both the retainer and a set of four brushes. The main job of the brush retainer is to hold a set of carbon brushes against the commutator bars located on the armature. If the brush retainer is worn, damaged, or improperly seated, it can cause problems with the equipment. The starter motor will not be able to get the proper amount of current from the battery.If the brush retainer might be causing problems, a visual inspection can be performed. A damaged brush retainer can wear down to the wire lead and become burned, pitted, or cracked. When the brush retainer is worn out, it can decrease engine performance, reduce braking, and cause the motor to lose power. This brush retainer is an authentic OEM replacement part sourced directly from the manufacturer. It is sold as an individual part. The retainer is made to be used with lawnmowers, snowblowers, tillers, and wood chippers created by Briggs & Stratton, Craftsman, Toro, Cub Cadet, Lawn-Boy, Snapper, MTD, and Simplicity.