Philip Craig for Model Number WFMC3200uc/01 Washer stopped during drain cycle. Repairman advised that Washer Motor Control Unit ID# 436461 was defective. I purchased and installed the newly acquired WMCU. First load was a hiccup and setting went from Warm and several minutes remaining to HOT and 1:00 hour remaining. Cut machine off, then started in Warm again and cycle resumed and finished nicely. 2nd load was perfect. Third load did well until Washer stopped and E:04 flashed in Start Finish window. What is E:04? and correction procedure. PLEASE ADVISE Thanks You
Answer Phillip, E:04 indicates an issue with the door lock assembly and/or the control module. " E:04 Door control broken Faulty Triac or control module " First check to see that there are no loose wires or connections at the door lock mechanism, and the assembly is properly mounted and secured to the front panel. Then check the wiring and connections at the control module, if all's OK replace the 00436436 Module, Control. Read More... Answered by AppliancePartsPros.com | Thursday, February 15, 2018