Vance for Model Number ggs30w Left burners don't light. No ignitor sound, no gas flow. Sometimes left rear will light but goes out 30 sec. later after rapid clicking sound and flame rapidly flickers. Left front does the same if I turn the knob all the way between lo and xlo but then goes out and doesn't try to relite. Right side burners work fine is it the spark module or simmer control that I need.
Answer Hi Vance. Make sure all burner caps have a "clean" spark path for the igniter to ground to. Use a small wire brush to clean contact points of the cap. The igniter itself need to ohm close to 0- .1 ohms , closed. Part # is 00189324. You need to gain access to the burner switches and check all connections. There is a wire harness you can get also, part # is 00189976. Burner wires carry 120 vac so make sure of your safety and remove power. Make sure all your orifices are not clogged. The burner switches are part # 00428049. Finally the spark module is part # 00753257. Thank You. Read More... Answered by AppliancePartsPros.com | Monday, October 24, 2011