Allen for Model Number 25326432100 My question is simmilar to peter's, on the controller. Possible low voltage running off a generator. Is there a way to check control board to be sure it is bad.
Answer Allen, Just like Pete, I'm sure you've got a damaged control. Solid state printed circuit board controls do not accept voltage fluctuations or amperage and wattage fluctuations (for that matter)very well. Any voltage below 105 volts, could damage a control, less than 102 VAC will damage a control, is a basic rule of thumb. You can check the high voltage power into the control and the voltage out to the compressor or heater depending on what cycle your on. Thanks and Good Luck Read More... Answered by AppliancePartsPros.com | Saturday, September 10, 2011