Justin for Model Number Frigidaire Affinity Frontload Replaced the water inlet valve after a hard freeze burst it, sending water down into the inside of the washer. But after I replaced it, I'm getting an error code of "E5E" and the suggestion is either the control board or motor control board is no good. I have no idea how to test them to check which one is bad, but I'm thinking that it's the motor control board because it was the only part exposed to the water. Your thoughts?
Answer Justin, You will want to check the wiring between the 2 boards first to make sure that there is no issue with the wiring. If the wiring checks ok then the speed control would be the most likely cause for the failure. Read More... Answered by AppliancePartsPros.com | Friday, March 4, 2016