Marc M. for Model Number ATF6000ES1 First, the door lock light didn't come on. I replaced the door lock switch. The lock door light came on. I thought I was good but when I turned on the machine the door lock light came on. Then there was a lot of clicking and no water was coming into the machine. I checked for a code and found an E56. (something about the motor) Is the next step? A motor control board 134743500? Thanks
Answer Hello Marc, 1. Remove the belt from the motor and spin the motor pulley. Does the motor spin free? No. Replace the motor. Yes. Go to step (3). 2. Spin the tub pulley. Does the tub spin free? No. Check the tub bearings. Yes. Go to step (3). 3. Disconnect the plug from the motor and measure the resistance of the windings (pin 1 to pin 2, pin 1 to pin 3, pin 2 to pin 3). All readings should be between 4 and 6 Ohms. If the readings are correct, replace the speed control board 134743500. If the readings are incorrect, replace the motor 137043000. Read More... Answered by AppliancePartsPros.com | Tuesday, December 4, 2018