Kurt for Model Number ATF6700FS1 Frigidaire Affinity Washer turns on, seems good to go, door locks, electric noise heard but no water comes in. Checked hoses, filters, etc. Won't do anything on spin only either, so seems not to be related to water intake.
Answer Hello Kurt, You should put the unit into the diagnostic mode to pull any fault codes stored. This is dos as follows: 1. Wake the washer by pressing any button. 2. Wait 5 seconds. 3. Press and HOLD the Start/Pause and Cancel buttons simultaneously. As long as the buttons are held, the failure code will appear in the display as an E followed by two numbers, a number and a letter or two letters. The control will beep and the Door Lock, Wash, Rinse, and Final Spin indicator lights will flash. This procedure is the best troubleshooting method of this unit and is used by technicians for diagnosis. Read More... Answered by AppliancePartsPros.com | Saturday, February 11, 2017