Matthew for Model Number 41781122310 Dryer runs about one minute then shuts down, then lights on right side top of control board flash, you can hit cancel button lights stop flashing, but the board won't turn off, stays on all the time. It gets warm, I can't figure it out.
Answer Matthew, the flashing lights are going to indicate either there is a stuck button or that there is an error code stored in the main control. It is recommended that the error code retrieval process is done to identify if there is a stored error code. This can be done by rotating the knob counter-clockwise three positions then pressing and holding the select and cancel buttons until the buzzer sounds. Once the busser sounds, press and hold the select and cancel buttons until the buzzer sounds three more times (the display will alternate between Fld and the firmware revision number). From there, rotate the knob two positions clockwise and the most recent error code will show in the display. If the display shows an error code, it will need to be addressed. If it does not, the control 137070890NH would be the most likely cause of failure. Read More... Answered by AppliancePartsPros.com | Monday, June 8, 2020