Mike for Model Number Frigidaire oven I am replacing an igniter. I have the part and am trying to install. That bottom panel will not pry out. I have removed the two screws in the back. I have pulled and pushed at all various angles. I even removed the protective panel of the convection fan. Any suggestions before I break something?
Answer Mike, " Removing Oven Bottom With the fan blade cover removed take out the two screws at the rear of the oven bottom panel. Lift the rear of the oven bottom up approximately 3 inches and slide the panel toward the rear of the range to disengage the front edge from the slot in the front frame. Lift the front edge of the panel above the edge of the front frame and remove the oven bottom panel. Remove the two screws securing the front of the bake burner baffle to the range chassis. Lift the front edge of the baffle high enough to clear the chassis and pull forward to disengage the rear tabs on the baffle from the slots in the oven liner. Remove the baffle from the oven cavity. With the baffle removed the bake burner and ignitor can be accessed for service. With the warmer drawer removed the wire harness plug connector for the ignitor can be disconnected. After the ignitor harness plug is disconnected, remove the two burner mounting screws and lift the burner assembly out of the range. The ignitor can now be separated from the bake burner assembly by removing the two ignitor mounting screws." Make sure you have the bake burner installed and aligned with the bake valve orifice when you reinstall the assembly. Good Luck Read More... Answered by AppliancePartsPros.com | Thursday, July 14, 2016