Customer Questions and Answers for Bottom Panel by Frigidaire

Maxine, each component of the oven door is sold separately and not in an entire door assembly. The following link can be used to view the oven door parts diagram. https://www.appliancepartspros.com/door-parts-for-electrolux-lgef3045kfk.html

Leroy, it would be recommended that the oven sensor 316490000 is tested for resistance. At room temperature, the resistance should be around 1100O. It can then be held tight in the hand and the sensor should start rising about 2O for every degree that it increases. If the sensor tests good, then the failure would be in the main control 316630003.

Janet, These screws that hold in the lower oven panel should be rounded and are considered finger screws but should have a slot for a flat blade screwdriver to go in to allow them to be removed.

Hello Ron. The model number will have to be verified on the units I.D. tag since the one listed came up invalid. This will be necessary to look up and specific parts such as the one you requested. Thank you for your patience and understanding in this matter. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx

Nick, At the back of the bottom panel there will be 2 screws that you will remove. Once you remove these screws you will lift the panel from the back and get it at an angle, slide the front from under the lip and take the panel out.

Hello Gary, I'm sorry but 316400601 is the correct bottom panel for the model provided. You will need to contact us at 1-877-477-7278 with the model and serial number for your unit and the order number so our representative can assist you in returning the part you ordered and ordering the one needed. Thank you for your patience and understanding in this matter.

Gary, You're following the procedure properly. Make sure you're not raising the back of the oven bottom panel too high. It may be getting caught between the bottom of the oven panel and the lip of the element burner base pan. Occasionally the burner base pan can get distorted, and hold the oven bottom panel, you may need to carefully shift the panel side to side and carefully push the panel back. You may want to wear some work gloves, and be very careful, you don't want to chip the front edge or the back wall of the oven cavity.

Hello Gaston. You will need to order 316505601 for the oven floor needed. Thank you.

Hello Gary. You will need to order 316400601 for the bottom panel needed for the unit. Thank you.

Hello Caroline, You will need to order 316505601 for the model provided.