Jim for Model Number PLD4375RFC0 On my Frigidaire dishwasher, # PLD4375RFC0, I got the ERR message, nothing worked. I replaced the console panel and the unit worked fine. I noticed after the first wash that the left side top of the console panel was wet and replaced the gasket. I believe that the first console panel failed because it was damaged on the left side top. My problem is there is still water coming out on the new console panel. The door latch seems to work OK. Do I need new door springs to close the door tighter or might it be that the tub is not aligned with the door?
Answer Hi. Just making sure that you have the control board gasket part # 154478901. Feel the inside of the inner door part # 5304460897 to see if it will seal fine or if it is warped and not sealing. Does the hinges, Lt. part # 5304513274 Rt. part # 154597701 make any noise or jump out of the pivot points when closing. If there is no smooth action then replace the hinges on each side. Remove the lower rack. Use a torpedo level on int the tub where the rack rolls on to see if the tub is level front to back and side to side. All 4 - legs have to touch the floor so the unit does not twist and misaligned the door latch during heated wash especially. Thank you. Read More... Answered by AppliancePartsPros.com | Tuesday, November 6, 2012