Robert for Model Number AEQ8700FE0 My dryer stops running after 10 seconds and lights on the right blink. I've replaced the control board but this did not change the issue. I cannot enter diagnostic or test modes. Prior to replacing the control board, the dryer would only run on low heat.
Answer Hello Robert, You should first press and hold the Select and Cancel buttons simultaneously for 6 seconds or disconnect power from the dryer. The dryer will be reset for regular operation. If not, check all connections and check the control panel for stuck keys. If normal operation is restored, pressing and holding the Select and Cancel buttons simultaneously for 6 seconds should reset the control. The buzzer should sound 1 time and “rES” will be shown briefly in the display. Read More... Answered by AppliancePartsPros.com | Tuesday, August 7, 2018