Ma for Model Number GE Fridge Model PSC23MSTC SS I purchased and replaced the main control board part no WR55X10942 due to problem with ice and water dispenser. Upon installation of new board, the fridge started working by dispensing both ice and water, but after 24 hours, the freezer compartment keep the temperature at set point, but the fridge side is still at 54 deg F. the board is not exactly the same as the one before, but it is the replacement part for this fridge. Is it possible that I have a bad temperature sensor or something else? Any guidance will be appreciated.
Answer Hello MA. You will need to check and make sure your serial number does not match those on the instruction sheet. If it is good, you will need to look for either a damper issue or a defrost issue with the unit. Check and see if there is any frost build up on the evaporator coils in the freezer. If so, you will need to test the defrost heater and the defrost thermostat. They should read closed for continuity when cold. You can test this with a multi-meter TJMA-DMT3. I will include a link at the end to assist you how to use the multi-meter if needed. Once the problem is repaired, you will need to thaw out the ice on the coils before the unit will operate properly. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More... Answered by AppliancePartsPros.com | Thursday, September 3, 2015