Russell for Model Number GSS25WGPABB I replaced the NEW WR55X10942 Control Board Motherboard In the directions it states cut pin 2 of j1 connector if it was a bottom freezer model and if an encoder serial with some model prefixes. sf2. I did cut pin 2 in J1. But I noticed that there wasn't a cable in pin1. Did I make an error?
Answer Hello Russell, I'm sorry but you will need to splice the wires back since it does not require this step. This should correct eh issue when the new board is correctly installed. Read More... Answered by AppliancePartsPros.com | Tuesday, September 17, 2019