Bob for Model Number GE whse5240dww washer would run, but not pump out and not go to spin. checked the basic lid switch, control knob, and plug/unplug reset process all to no avail. checked power into pump, only about 56V. Fed AC 110V direct to pump, pump seems to work fine, pumped out. Seems like not getting signal/voltage from controller.? what else can i check to confirm, is there anywhere to check for specific codes or does this sound like typical controller fault. I just want to order the correct parts as controller is pricey thanks, Bob
Answer Hello Bob. Make sure your wiring is good and double check the lid switch. If all is good, then you will need to replace the control board on the unit. Read More... Answered by AppliancePartsPros.com | Tuesday, July 19, 2016