Bangbang for Model Number WBVH6240HWW I recently changed out my board due to the unit not working properly (if you pressed the soil level button the spin speed or wash temperature would move). Now those all work like they are suppose to but now when I select drain and spin it fills with water (the complete opposite of what it is supposed to do. Is the new board bad?
Answer Hello Bangbang, The control on this unit requires programming. To do this, the tech sheet says: • The replacement control board will always enter into test mode t01 on initial power-up. • If replacing the control board, the washer will not function until the replacement control board has been programmed. To program the replacement control board: 1. Reconnect power to the washer. (The display will now show “---”, which means no model has been selected). 2. Rotate the cycle knob until the correct model number is displayed: Select 1 for models WHDVH626, WHDVH660, GHDVH626 and GHDVH670. Select 2 for model WCVH6260. Select 3 for model WBVH6240. Select 4 for models WCVH6600, GCVH6260 and GCVH6600 3. Press and hold the Start key for 3 seconds (or until a second beep is sounded). 4. Press the Power key to reset the control. Note: If an error is made in programming the control, enter test mode and select t01. Then repeat steps 2 through 4. If this does no good you should pull the tech sheet and run the diagnostics to see if there are any stored codes. Read More... Answered by AppliancePartsPros.com | Friday, June 17, 2016