Raymond C. for Model Number GLD4400N10WW Sometimes you push start on the dishwasher and it will sound like the water is coming in a little then the lights start blinking, the heat will come on and then it will stop completely. If I push reset about 10 times it will come back on and sometimes will go through a complete cycle and other times it will stop after a few minutes. Do you think it is the master board that needs replacement. Thanks, Ray
Answer Hello Raymond, It could be the main control board, but I would check the wire nuts at the power supply connection behind the kick panel first. I have found by following other technicians that a lot of control boards are replaced for no reason and I find more burned wire nuts than you would think. The lights blinking is the thing that leads me to this conclusion. If this isn't the case, I would check the other connections at the control before I ordered anything. Next, discontinue power to the unit to try to reset the microprocessor on the control WD21X10247. If no bad connections are found, then the last resort is the control. Read More... Answered by AppliancePartsPros.com | Thursday, April 5, 2012