Robert for Model Number JGBP40BEC4WH Hi. GE XL44. My broiler doesn't light but my oven does. I bought a new igniter from you and installed it. Ohm reading similar between old and new igniters, but I installed it anyway since it was the original and I already had it out. Broiler still doesn't light. oven lights fine, and since my safety valve is dual, it should be good? Also self clean does not light either over or broiler. I made sure the connection was good at the igniter and connector also. Is there a fuse or relay perhaps. I still need to pull the sove back out and measure for voltage TO the igniter. If there is voltage what then, if there is no voltage what then? Stove is about ten years old and wife wants a new double oven. If the repair is expensive I might just cut my losses. Thanks for your help.
Answer Robert, When checking to see if the issue is the power to the igniter then test for 3.2 to 3.6 vac at the oven safety valve. If there is not power there then the igniter is most likely not getting power since new igniter was installed. This would be a control board issue if that is the case. If there is proper power there are the broil is not igniting then the safety valve would be the issue. Read More... Answered by AppliancePartsPros.com | Friday, February 6, 2015