Judith for Model Number GE Profile PDW8800JO3BB In January my dishwasher stopped in the regular cycle before the soap was released. There was about an inch of water left in the bottom and the keypad was dark and non functional. Two days later it mysteriously started up and finished the cycle and continued to work perfectly until last Friday. Same thing happened. We took the door apart on Sat and tested it for power. There is power to all components i.e the door switch, the control board and the keypad. When we depress the door switch manually power goes to the soap dispenser too. But when we depress the switch no lights and no motor start up. We reassembled it and lo and behold again in a few hours later it started up! I opened the door and then closed it and boom - no lights, no nothing again. Yesterday I cleaned out the whole bottom removing the coarse filter, spray arms, filter basket etc. LOTS of junk. Still no lights etc. I did see that the tube sticking out of the sump was pretty deteriorated but the fine filter was able to go into it. Could that be the cause or could the door switch be faulty. Seem like the keypad and control board are working. Any help would be appreciated.
Answer Judith, This issue would most likely be caused by a faulty main control board on the unit. Read More... Answered by AppliancePartsPros.com | Monday, May 14, 2018