Customer Questions and Answers for Terminal Block Assembly by Ge

Don, Here's some help," 3-wire or 4-wire Plug Connection Four-wire cord is required for mobile homes or where codes do not permit grounding through neutral. 1. Remove access cover from rear of dryer. 2. Use a strain relief and insert end of power cord through power supply hole. 3. Use the three screws from envelope located in the drum to attach the remaining power cord wires to the terminal block as follows: • Red wire or left side wire terminal to “L1” terminal (left side outer terminal.) • Black wire or right side wire terminal to “L2” terminal.(right side outer terminal) • White wire or center terminal to Neutral terminal (center terminal). • 4-wire Plug Only—Remove ground screw and detach ground wire from bulkhead. Attach power cord ground (green) wire to rear bulkhead using ground screw. Attach free ground wire, previously attached with ground screw, with white wire to the neutral (center) terminal on the terminal block." Good Luck and Thanks