Wil for Model Number wpse4200aoww guys I have replaced the press. switch, water valve, and the press. switch hose but, my problem has not been resolved... if I do not supervise the washer water will overflow as stated before the issue here is the different water settings its not recognizing the different water levels so, what is next? I have to ask does the main board control or send any kind of signals to the water valve or press. switch ? I have asked this question if I should replace the main board but, you have recommended other things to replace. please advise, I am very disappointed at this time really need to repair this problem. Wil
Answer Will, When you were working with the press. switch hose, did you check and make sure the attachment port on the side of the tub was clear and free of debris, or water/detergent deposits ? With the work and parts you've done, the issue should have been solved, unless the tub port is blocked or you have a control board issue, Blow in the press. switch hose when you disconnect it from the press. switch. At the main control board, 11 pin harness connector(not the board connector) , pin 4 and across to pin 7, should be an "open" circuit. If you carefully blow into the Press. switch, until you hear ir "click" the circuit should be "closed" If all's OK, then replace the control board WH12X10169. Good Luck and Thanks Read More... Answered by AppliancePartsPros.com | Monday, May 7, 2012