Customer Questions and Answers for Washer Door Boot Gasket by Lg

Hello Gabe. Here are the instructions from the manufacture. Hope this helps. ?? Unscrew 2 screws on the back of the top plate. ?? Pull the top plate backward and upward. ?? Disconnect the connectors from the Main PWB Assembly ?? Pull out the drawer and unscrew 2 screws. ?? Lift the left side of the Control Panel Assembly and pull it out. ?? Pull out the control Panel unscrew 1 screws. ?? Pull out the drawer. ?? Push out the DISPENSER ASSEMBLY after unscrew 2 screws. ?? Unscrew the 3 screws from upper of the canbinet cover. ?? Unscrew the screw from filter cover. ?? Put a flat ( - ) screwdriver or putty knife into the both sides of the filter cover, and pull it out. ?? Unscrew the screw from the lower side of the cabinet cover. ?? Open the door. ?? Disassemble the clamp assembly. ?? Tilt the cabinet cover. ?? Disconnect the door switch connector. ?? Lift and separate the cabinet cover. ?? Disassemble the clamp assembly. ?? Disassemble the Gasket. ?? Reinstall in reverse order.