Darin for Model Number WF331AWXAA 04 (Canadian} I've had an OE error, which was corrected after running a few wash cycles after replacing the over flow switch. Getting the same error again after only a year with the replacement part, but usually only when running the washer in Normal setting. When this occurs, we usually run the washer in the quick wash setting where it rarely generates the error. The other issue, has been the cold water runs continuously when running a normal wash cycle, despite setting the washer temp. to Hot/Cold. This also occurred recently when trying to run the pure cycle setting. The cold water ran for about 2 hours before I realized this, even though the timer indicated the cycle only ran down to 182 minutes from a start of 201 minutes. This problem hasn't occurred during the Quick Wash setting. Is the control board the problem or a stuck cold water valve?
Answer Hello Darin, we do not have any part information on this model as it is a Canadian version, however, the cold water valve should not be running that long, the washer's control board powers the water valve at the start for fill up and then cuts power to the valve. If the valve is still open then you will get an overflow code. In that case, replace the water valve, also check the drain hose is not down too far down which can cause a siphon of the tub water. Read More... Answered by AppliancePartsPros.com | Monday, January 3, 2022