Eddie for Model Number WV60M9900AV/A5-01 Hi, My washer starts off well and then suddenly it stops. The timer still shows minutes on it but the washer simply stops. I push the start/pause button and it will continue. then it will happen again, usually at the end of the cycle. It stops with water in the drum. I push the button again and it will drain.. One time (only one time) I got a 3C on the error on the display. Do you think it could be the PCB? Thank you
Answer Eddie, it would be recommended that the stator DC97-19994B is tested for resistance and it should measure between 10.2 to 12.4 Ohms. If it tests good, the wires would need to be checked from the stator and RPS sensor to the motor control DC92-01531C. If there is not a loose, broken, or bare wire, the motor control is the likely cause of failure. Read More... Answered by AppliancePartsPros.com | Monday, July 25, 2022