Eli for Model Number WF328AAW/XAA hello, i took my samsung front washer apart and replaced the spider with drive gear and pump. Had no problem with anything else. I put it back and it pumps and tries to spin then displays E3 error. I pulled the stator off with the sensor position which is attached. I'm reading 11.4 ohms touching any of the 2 terminals. From the answers i read, one said 11.5 ohms, another said 6 and another site said 9.2 ohms. Anyways, what else can i do to keep the process of elimination going. model:WF328AAW/XAA
Answer Eli, Start with placing the machine into service mode: to enter press Signal & Extra Rinse simultaneously with the power on. Then run the Quick Spin Test: to enter this press; Delay Start & Silver Care. This accelerates the drum motor from 0 to maximum RPM over a few minutes. Note: Stay with the washer during this test, the out-of-balance detection is bypassed and the door may not lock. Press the Start/Pause button during the test to hold its spinning speed. Read More... Answered by AppliancePartsPros.com | Wednesday, January 24, 2024