Rob for Model Number RVC36 Is there a procedure to installing the control board. My unit goes up and down randomly Was lucky enough to find a new control board so want to be careful not to screw up the installation. I can see the cap that comes off but don't see how to remove it. And also of there is a procedure for cleaning the buttons, and since it is an older unit how to make the buttons less brittle.
Answer Hello Rob. KEYPAD, KEYBOARD REPLACEMENT RV SERIES RAISED VENT Removal of the cooktop is not required. ? Raise the vent sleeve by pressing the UP/DOWN button. If the unit is dead, raise the vent by removing the black motor sleeve wires L3 and N3 from the main PCB and hook direct to a power source (Auxiliary power cord, pigtail etc) ? With the vent in up position turn off the electrical power to the vent and remove the vent electric cover plate. ? If a cabinet blower is used, disconnect the blower from the vent by loosening the three wing nuts located above the blower and lifting up on the blower retaining bracket. ? If a remote blower is used remove the cover plate. ? Disconnect the 14 wire Molex plug from the main PCB. ? Remove the screws, 1 on each side of the sleeve. Lift top cap assembly from the sleeve assembly. Guide the Molex plug through the electric box and through the channel in the sleeve assembly. ? Remove the right end cap (pressed in). Slide out the bezel, keypad and keyboard as one unit. Replace desired part and reinstall in reverse order. Read More... Answered by AppliancePartsPros.com | Wednesday, January 21, 2015