Al for Model Number WFW9200SQ00 My washer will turn on for a couple minutes then stop then I get a f70 code on the display. I try to restart it and it will not just beeps, I can then unplug it for awhile then replug it in and it will start and do the same thing again. I was reading some blogs and it seems it might be the electronic control board how can i check this?
Answer Al, The F70 error code indicates a problem between the CCU(central control unit) and the U/I(user interface). You will want to retrieve the tech data sheet from the inside of the lower access panel on the front of the washer. Program the control for the diagnostics test and review the error codes logged into the memory of the control, then allow the washer to advance into the test mode or program the test mode and observe the washer operate. If all's OK, remove power to the washer, remove the top panel and check and clean all the wire harness connections at the CCU and the U/I, make sure all the connections are proper and have a tight fit. Read More... Answered by AppliancePartsPros.com | Friday, May 6, 2016