William for Model Number nfw7200tw Do I need board? Starting load, just as spin starts,after wash,pump comes on,all process stops(on quick wash-19 min.) @9min.. It usually comes back on and finishes load. When not,I can push start knob,it pauses,push again and it finishes where it left off. Any input?
Answer Hi William. A few things come to mind as you have this issue ? Is the door staying locked during this pause mode ? Either go through the back cover-or- by removing the top, console and the front panel all in effort to go to the pump. If the pump is clogged then the control board will see a non pump signal from the pressure switch to allow the spin. Then it will shut down after a period of time. Make sure the tub to pump hose is clear. Inside the cabinet top in a folded packet is a supplied tech sheet to use. Put this in a field service mode to get the unit to check all components and send a fault code on the circuit in need of repair. The pump is part # WP34001340. Also make sure the fill hose inlet valve screens are clear to allow the proper fill time. Thank You. Read More... Answered by AppliancePartsPros.com | Wednesday, April 18, 2012