Mike P for Model Number RBD305PDS15 I purchased the touch panel and replacement control board (AP60214141 [W10438752 G REV B]) from you to replace my old ones. The original control board is Whirlpool part # 4463664. The connections for the boards are identical EXCEPT the new replacement board does no have the P27 connector. The Electronic control pinout spec sheet indicates the two pins being used were "not connected" any way so I wasn't too worried about that. I replaced the parts and everything for now works fine EXCEPT the oven light is backwards. When the oven door is closed the light is on and I cannot turn it off. When the door is open the light is out but can be turned on. It seems the switch connected to the oven door is backwards than what it was before. I switched the wires with no luck. I disconnected the wires but got an error message. Right now I just took the bulbs in the two ovens out but know that won't last long before the wife complains. Any ideas? If I could reverse the oven door switch (pressed in off - out on) I would be golden. Something is wired backwards and I am not smart enough to figure it out. HELP!
Answer Mike, The part number that shows as being the correct control board for your unit would be WPW10438751 and the W10438752 is not showing for your unit. Read More... Answered by AppliancePartsPros.com | Thursday, December 22, 2016