Joe C for Model Number MAH5500bww My Maytag washer will not fill up with cold water. Hot water works fine. I have already checked and replaced the valve & hoses. That didnt make a difference. I put the washer into servie mode and it will not fill with cold water. It fills with hot and runs through the other cycles no problem. What else could it be?
Answer Joe, You will want to check on the control board with the unit set for cold water fill from connector P1 Pin 4 to P8 pin 2 for 120 vac when filling. If there is not 120 vac then the control board is bad and would need to be replaced. This would be the most likely cause. Read More... Answered by AppliancePartsPros.com | Monday, August 12, 2013