Dan for Model Number kuds01djss0 My dishwasher will heat during both the wash and dry cycles. Total cycle time is approximately 2 1/2 hours long. Incoming water temp at the kitchen faucet is 122F, and is approximately 100F in the d/w tub just after filling. Water temp in the d/w remains at approximately 100F for the first 45-60 minutes before cooling down. The "sensing", "add-a-dish", and "water heating" lights on the control panel remain lit during the entire cycle. Continuity test results of the various heating components are as follows: Thermal fuse .3 Ohms Hi-limit thermostat .6-.8 Ohms Thermistor 59-60K Ohms @ 69F room temp Heating element 9.6-10 Ohms I cannot find any loose or damaged electrical connections, nor any damaged wiring. I do not know how to test the control board. Any ideas? Thanks.
Answer Dan, It sounds like the unit is operating per specs. The dishwasher will try to heat the water to 140 degrees and if it cannot reach that temp within a certain amount of time it will progress through. You will want to make sure that the internal water temperature in the bottom of the dishwasher is a minimum of 120 degrees for the unit to operate properly. Read More... Answered by AppliancePartsPros.com | Thursday, May 9, 2013