Customer Questions and Answers for Surface Burner Spark Electrode by Whirlpool

Hello Nick. Here are the instructions from the manufacture. Hope this helps. Main Top Removal 1. Shut off gas supply and disconnect electricity to unit. 2. Remove grates, caps, and knobs. NOTE: To remove knob(s), slide a rag under the knob and pull upward. 3. Remove cooktop from installation position and place on protected surface. 4. Remove screws securing burner base to orifice holder. 5. Lift upward on burner base, disconnect ignitor wire, and remove burner base, (auto reignition models only). 6. Remove main top by lifting off burner box. NOTE: Top is secured with double-sided tape in front. 7. Reverse procedure to reinstall. Spark Module Removal 1. Remove main top, see "Main Top Removal" procedure. 2. Remove spark module from bracket. 3. Disconnect and label wire leads from spark module. NOTE: Mark wires for exact replacement on module. 4. Replace module and reverse procedure to reinstall. Surface Ignitor Removal 1. Remove main top, see "Main Top Removal" procedure. 2. Disconnect ignitor wire from ignitor. 3. Remove screw securing ignitor to orifice holder and remove ignitor. 4. Replace ignitor and reverse procedure to reinstall.