Customer Questions and Answers for User Interface (Pewter) by Whirlpool

Hello Kent. That is a thermistor error. The machine control electronics monitors the exhaust temperature using the thermistor, and cycles the heater relay on and off to maintain the desired temperature. Begin with an empty dryer and a clean lint screen. 1. Plug in dryer or reconnect power. 2. Set the following configuration: ? Door – must be firmly closed ? Press Control On ? Press End Of Cycle Signal (Louder) ? Press Start 3. If after 60 seconds, E1 or E2 flashes in the display and the dryer shuts off, the thermistor or wire harness is either shorted or open. ? Unplug dryer or disconnect power. ? Check wire connections at the machine control electronics and thermistor. See Accessing & Removing the Electronic Assemblies, page 7, and figure 8 for thermistor location. ? If wire connections are good, remove the two wires from the thermistor and replace the thermistor. See figure 8. ? Plug in dryer or reconnect power.