Formico for Model Number GSW9800PW2 Water will not fill with any of the settings - wash or rinse. We took the hoses off and verified there is good water pressure to the washing machine. We visually checked the water inlet valve and it appeared to be very clean. We removed the water inlet valve and tested it on a digital multimeter GDT-311, With the ohm setting on 200 we do not get a reading and the meter remains at 1. With the ohm setting at 2000 we get a reading of 788 and 784 on the two solenoids. The procedure indicates a reading of 500 to 1500 indicates the unit is electronically good. Did we do this correctly? We also tested the lid switch. On ours there is three prongs. If I set the multimeter to 200 on the middle prong and prong closest to the front of the washer we get a reading of 1.3. We do not get a reading with any other combinations on the switch. Are either of these the issue? Please let us know what to do next. Thank You, Formico
Answer Hello Formico, if the washer will not fill or go into drain/ spin then check there is 120v going to the washer, next as a test, jump out the lid switch and test the washer, Read More... Answered by AppliancePartsPros.com | Thursday, June 2, 2022