Justin Kunak for Model Number WTW6200VW0 I have a whirlpool cabrio washer model number WTW6200VW0.I wrote to your not long ago on my washer and i did all your recommended me to do and i am still having problems.my washer starts out good washing and goes into drain cycle and pump drains water then it gets caught in that mood after water finish draining,the tub spins stops and spins other direction and gets on doing that.I was told my unit didnot have a calbriation model on it but it did have a water level transducer recalbriation mode and i did that calbriation.I was also told to check air hose from board to tub and make sure it was good and tight and that was okay.I was told to run the diagnois test also and check for error coded but washer has no error codes.I try and run it through the automatic diagnois test mode and it does good up till it gets to that drain stage it drains tub but even in the mode it locks up and wont let washer go any further and it does not give a error code.On the owners manuel on the washer it says if that happens to start the test all over again.I did that 3 times and with the same results,locks up in the same stage.I have already rebuilt washer i replaced rod kit,shaft and beaaring and seal,rotor and the stator,and the rotor sensor and the basket hub.Alot of those parts were worn out causing the UL code on washer,now the washer does good and no more UL code up until it locks itself up after the drain cycle.I am floored about my washer and dont know what the problem could be.I hope your might have some other ideas i can check on washer.i am wondering if something might be wrong with control board?With all that i have done and checked on,do your think that might be a possibility.Thanks so much for your time,i hope your will be able to shed some light on my problem and help me with my washer.
Answer Justin K, It sounds like you have changed out about all of the mechanical parts and it is possible your control is the issue therefore it is not giving an error. Based on the information provided the changing of the board is the only way left to rule it out. Read More... Answered by AppliancePartsPros.com | Wednesday, October 28, 2020